What is happening inside the wall or ceiling
Water follows gravity and the path of least resistance. A leak from a roof, an upstairs bathroom, a pipe, an air conditioner drain line or a condensate pan travels along framing, drywall and cables until it finds a low point or an opening. Electrical boxes, recessed lights, ceiling fans and fixtures are openings. Cables run through the same cavities, so water that follows a cable can end up inside a fixture box, a switch box or an outlet, and then drip out of the device onto the floor or onto you.
The water is often dirty and carries minerals, insulation fibers and rust, which makes it a better conductor than clean water. It can touch the live parts inside a fixture or a box, which can trip a breaker, cause a short circuit, make the fixture buzz or smoke, or energize metal parts such as a fan blade, a switch plate or a recessed light trim. A fixture that is filling with water, such as a dome light with water pooling in the glass, can also pull away from the ceiling because of the weight, bringing water and live wires down together.
Safety first: deal with the circuit before the water
The order matters. The first priority is to remove power from the circuit that serves the wet device, because water and live parts together are the danger. The second is to stop and catch the water. Do not touch the fixture, the switch, the outlet, the fan or the ceiling area around it while it is wet and power is on. Do not stand on a wet floor under a dripping fixture while using a switch. Do not turn the light switch on or off to test whether the device works.

To remove power, go to the breaker panel, but only if the path to the panel is dry and you are not standing in water. Switch off the breaker for that room or area. If you do not know which breaker it is, switching off the main breaker is the more cautious choice. If you cannot reach the panel without crossing wet floors, or if you see smoke, sparks, a burning smell or hear a buzzing sound from the fixture, leave the room, keep others away, and call. If there is fire or smoke, call 911 first. See how to find your main breaker if you need help locating it.
- Do not touch the wet fixture, switch or outlet, and do not flip switches to test them.
- Reach the panel only along a dry path while dry yourself.
- Turn off the breaker for the area, or the main if you are not sure.
- Leave and call 911 if you see smoke or flame or smell burning.
- Then deal with the water, away from the live fixture.
Catching and stopping the water
Once the power is off, protect the room. Place a bucket or a large container under the drip and move furniture, rugs and electronics out of the way. Cover items you cannot move with plastic sheeting. If the water is coming from a plumbing leak above, such as a bathroom or kitchen on the floor over you, turn off the water supply to that fixture or the main water supply to the house, which is usually near the street side of the home or at the water meter. If it is a roof leak during rain, the source cannot be fixed until the rain stops; the immediate goal is to keep the water contained and the power off.
If the ceiling is bulging with trapped water, that is a risk of sudden collapse. Do not stand under it. Some people puncture the bulge to release the water in a controlled way, but that is dangerous near electrical fixtures and wiring and should be left to a professional if there is any wiring or fixture nearby. If the ceiling has already begun to sag around a light fixture, stay out of the room and call. Our page on wet attics and ceiling lights after a storm covers what to look for when the leak is storm related.
- Contain the drip with buckets and move belongings.
- Turn off the water supply if a pipe or appliance is the source.
- Do not stand under a bulging, sagging ceiling.
- Do not puncture a ceiling near a fixture or wiring.
Light fixtures, recessed lights and ceiling fans
Each type of device behaves differently. A surface-mounted dome or flush light can fill with water and keep the glass or plastic cover full. Recessed lights, also called can lights, are open to the ceiling cavity, so water coming from above can run down the housing and out of the trim, and insulation above them can hold water and then drop it. A ceiling fan with a light kit can collect water in the canopy and drip it down the downrod, along the blades or from the light cups. Water in the canopy is next to the wires in the ceiling box.
In every case, power must be off before anyone goes near it. Do not try to remove a fixture full of water, because the weight can pull it from the ceiling and the wires inside may be live or damaged. Do not unscrew bulbs from a wet fixture while the power is on. Once a technician has made it safe, the fixture, and often the wiring in the box, needs to be inspected, and a fixture that has been wet is usually replaced. Our page on urgent ceiling fan and fixture faults describes how those repairs are approached.
Outlets and switches on a wet wall
Water can also come from a wall. A pipe leak behind a wall, a leaking window or door frame, roof water running down the stud cavity, or water sprayed against an exterior wall can enter a box and run out of a receptacle or a switch. Outlets in kitchens, bathrooms, laundry rooms, garages and exterior walls are most exposed. You may see water beading on a cover plate, hear a hiss or a buzz, notice a discolored plate or smell something hot.
Do not plug anything in, do not unplug items that are plugged into a wet outlet unless the power is off, and do not touch the cover plate with wet hands. Turn off the breaker. A ground fault protected outlet or breaker, often called a GFCI, may have tripped to protect you, and that is a reason to leave it alone, not to reset it. If a GFCI keeps tripping after water exposure, the device or the wiring behind it may be wet or damaged; see a GFCI that will not reset. Water that has been in a box can leave corrosion and residue, which cause failures later, so inspection is needed even if the outlet seems to work again after it dries.
- Do not plug in or unplug devices at a wet outlet while the power is on.
- Do not reset a GFCI that tripped because of water until the area has been checked.
- Beaded water, a hiss, a buzz or a burning smell means keep the breaker off.
- Dry-looking outlets can still have wet wiring behind them.
What not to do, and common mistakes
Several actions that seem sensible make this situation worse. Wiping a wet fixture or plate with a towel while the power is on can put your hand in contact with live metal. Using a wet vacuum, a squeegee or a mop under a live dripping fixture creates a path for current through the water and the tool. Waiting for the leak to stop before turning off the power lets a short circuit develop. Turning the breaker back on to see whether the light works after it dried is a common cause of damage and fire. Covering the fixture with plastic bags while it is live traps heat and moisture.
Another mistake is to treat the electrical issue as solved when the dripping stops. Moisture sits in insulation, in the ceiling cavity and in wire connections long after the visible dripping has stopped. Connections that were wet can corrode, and wires with damaged insulation can short later. Plan on an inspection before the circuit is used again. See water getting into the electrical panel for the related situation at the panel itself, and wet hands, wet floors and electricity for the basic safety logic.
When to call 911 and when to call an electrician
Call 911 if you see flames, smoke, or sparks, if the ceiling or fixture is burning, if someone has been shocked, or if the situation is dangerous and you cannot make it safe. Leave the building if there is fire or heavy smoke, and call from outside. If someone has been shocked, do not touch them until the power is off; our page on a person shocked at home describes the steps.
Call an electrician when water has entered a fixture, fan, outlet, switch or junction box, even if the breaker is now off and no one has been hurt, because the circuit needs to be inspected before it is used. Call earlier rather than later if the leak is large, if more than one device is wet, if breakers are tripping, or if the water is near the panel. Also call a plumber or a roofer for the leak. The electrician handles the electrical side and the other tradesperson handles the source, and the two often need to happen in a sensible order so that the repaired circuit is not wet again.
What the technician will check
With the circuit off and verified, the technician inspects the wet device, the box behind it and the cable that serves it. They look for moisture, corrosion, discolored or melted insulation, loose connections and signs of arcing. They test the circuit for insulation resistance and for shorts to ground, and they may trace the cable back through the ceiling or wall to find where water has traveled. Fixtures and devices that were soaked are generally replaced; boxes that are rusted or damaged are replaced; and damaged cable sections are repaired or replaced.
If the leak affected more than one device, the technician may test the whole circuit and the breaker. If the wiring is old, such as fabric-covered or aluminum branch circuits, water exposure can reveal problems that were already developing. The technician will also check that ground fault and arc fault protection is working. Our pages on urgent outlet repair, urgent switch and dimmer repair and urgent short circuit location describe those tasks.
Complicated repairs usually need an on-site visit before a quote can be given, and quotes are given only by phone. A service call charge applies and is explained on the phone before dispatch.
- Device, box and cable inspected for moisture and corrosion.
- Circuit tested for shorts and insulation problems.
- Wet fixtures and devices replaced.
- Protection devices tested after repairs.
Condos, rentals and upstairs neighbors
In a condo or apartment building, water through a ceiling light is often from the unit above, a shared riser, or a roof leak. Tell the building manager or association right away so they can find the source and stop it, and tell the neighbor above if you can. Water traveling through the building can reach electrical rooms and panels, so reporting quickly helps protect others. If you rent, tell your landlord or property manager in writing, and keep a record. See home or rental: which repair is yours for who usually handles what.
Take photographs from a safe position of the leak, the fixture, the ceiling and any damaged belongings, with the power off. Note dates and times. These records help with insurance and with sorting out who is responsible. Do not wait for the neighbor or building to fix the source before calling an electrician, since the electrical hazard exists as long as the circuit is wet.
Having the call go smoothly
Tell the dispatcher what is wet: a ceiling light, a fan, a recessed fixture, an outlet or a switch. Say where the water appears to come from, whether the breaker is off, whether anything smells hot or was sparking, whether there is standing water, and whether the ceiling is bulging or sagging. Give the address and the building type, and say whether you own or rent. If someone depends on powered medical equipment, say so.
While you wait, keep people out of the room, keep the circuit off, keep the water contained, and do not test the switch. Clear a path to the panel and to the wet fixture for the technician. If the leak is from a storm, take a photograph of the roof or ceiling from a safe place. When water has found its way into a light or an outlet, the safe approach is simple: power off, water contained, nothing touched. Call so a qualified technician can inspect the circuit and make it safe before it goes back into use.
Questions people ask
Is it dangerous if water drips from a ceiling light?
Yes. Water can reach the live wires in the fixture, short the circuit, or energize metal parts. Do not touch the fixture or switch while it is wet and powered. Turn off the breaker if you can reach the panel by a dry path. If there is smoke, sparks or a burning smell, leave and call 911.
Can I just turn off the light switch?
Not safely. A wall switch does not remove power from every part of the circuit, and touching a wet switch is risky. Use the breaker. If you cannot reach the panel without crossing water or wet floors, stay out and call. The main breaker is the cautious choice if you do not know the right one.
Do I need an electrician if the water stopped and the light works?
Yes. Moisture lingers in the box, the ceiling and the wire connections, and corrosion or damaged insulation can cause problems later. A technician can check the circuit before it is used again, and replace fixtures and devices that were soaked. Do not turn the breaker on to test it.
Should I reset a GFCI that tripped after water got in?
Not until the area has been checked. A GFCI that trips after water exposure is doing its job. If it will not reset or keeps tripping, there may still be moisture or damage in the device or the wiring behind it. Leave the circuit off and call a technician to inspect.
Water is coming from the apartment above. Who do I tell?
Tell the building manager or association immediately so they can find and stop the source, and tell your landlord if you rent. Turn off the breaker for the wet area and keep away from wet fixtures. An electrician can inspect your circuit while the building deals with the leak.
What if the ceiling is sagging around the light?
Stay out of the room. A sagging ceiling may hold a large amount of water and can fall, bringing the fixture and wires with it. Keep the circuit off if you can reach the panel by a dry path, keep others away, and call. Do not puncture the ceiling near wiring or a fixture.
If "Water Coming Out of a Light or Outlet" matches what is happening, call and describe it plainly: the room, the breaker, any burning smell or tripped circuit. We explain what the repair would involve before a visit is set.
Related pages
- Water in Panel: Water reaching an electrical panel is serious. Learn when to shut the main, when to stay out, what causes intrusion, and what an electrician checks first.
- Wet Attic Lights: A roof leak can send water along wiring into ceiling lights. Learn what is safe to do, what to leave alone, and how an electrician triages a wet ceiling.
- Wet Floors and Shock: Why moisture changes electrical risk, how wet skin and wet floors raise shock danger, and how to position yourself and get help when water is near power.
- Outlet Repair: A dead, warm or heat-damaged outlet needs attention. Learn what is safe to do, how a technician repairs a receptacle, traces the cause and how to prepare.
- GFCI Won't Reset: A GFCI that will not reset means a fault or a failed device. Learn what safe checks you can do, what to avoid, and how to describe the problem by phone.
- Surge Device Failed: A whole-house surge device with a red light, alarm or burn marks has done its job or failed. Learn what the indicator means and what to do after a big surge.
