Electrical help for homes and businessesRequest service
Emergency ElectricianCall (954) 481-0910
Electrical diagnostic camera, insulated tools, safety glasses, gloves, and Emergency Electrician branded equipment

Emergencies

Half of the House Lost Power

A split outage, where some lights and outlets work and others do not, is a pattern electricians take seriously. It can be a simple tripped breaker or a lost leg of the service. This page explains how to read the pattern from the outside and what to leave alone.

Why a split outage is different from a normal outage

Most American homes are fed by a split-phase service: two hot conductors, each carrying about half of the household supply, plus a shared neutral. Lights and most outlets use one hot and the neutral. Large loads such as the electric range, the dryer, the water heater and the central air conditioner use both hots together. The panel divides the branch circuits between the two sides, so the circuits on one side of the panel are fed by one hot, and the circuits on the other side by the other.

When one of those hots is lost, half of the house goes dark. The other half may keep working, often with odd symptoms. Lights on the live side may seem normal, or they may flicker or burn brighter or dimmer than usual. Large 240-volt appliances stop working altogether, because they need both hots. An air conditioner that will not start and a range that is dead while some lights still work is a classic sign. The loss can happen in the utility's line, in the meter, in the service conductors, or in the main breaker or the panel. It is not something that can be diagnosed from the couch.

First, rule out the simple explanations

Not every half-house outage is a lost leg. Start by looking for a tripped breaker. In the panel, find any breakers that are in the middle position or OFF. A single tripped two-pole breaker, which is a wide breaker with two switches tied together, can cut off a range, a dryer or an air conditioner, but it will not cut off a whole half of the house. A tripped GFCI outlet can cut off outlets in several rooms, such as the garage, the bathrooms and the outdoor receptacles, which can look like a split outage when it is not. Check the test and reset buttons on any GFCI outlets in the bathrooms, kitchen, garage and outside. Our page on a GFCI that will not reset covers that case.

Emergency Electrician technician repairing and testing a wall outlet in a South Florida home

Also consider that the dark rooms may simply be on one circuit or one breaker. Check whether the outage follows a pattern that matches the panel labels. If a handful of adjacent rooms are dark and the panel shows one tripped breaker for them, that is a normal circuit trip. If large parts of the house on opposite ends are dark, or if both lights and 240-volt appliances are out at the same time, the pattern suggests a lost leg.

  • Look for a tripped breaker, especially a wide two-pole breaker.
  • Press the reset button on GFCI outlets in the kitchen, bathrooms, garage and outdoors.
  • Check whether the dark areas match one circuit or span many unrelated circuits.
  • Note which large appliances still work and which do not.

What a lost leg looks like in daily life

The most obvious signs are lights and outlets that are dead on one side of the house, an electric stove or dryer that does not heat, an air conditioner that will not start or runs but does not cool, and lights that act strangely. On the side that still has power, the voltage can be unstable. Sometimes lights are much dimmer than normal; sometimes they are much brighter. Both can happen because a failed neutral or a lost leg changes how the load is shared between the two sides.

Electronics are at risk when that happens. A TV, a computer or a modem plugged into the side with abnormal voltage can be damaged, and appliances with motors can overheat. If you notice that lights are unusually bright or dim, or that something smells hot, unplug sensitive electronics and turn off the main breaker if you can do so safely. See our pages on lights that are suddenly too bright and loose neutral symptoms for the related patterns.

  • Half of the lights and outlets dead, half working.
  • Electric range, dryer, water heater or air conditioner not working.
  • Lights on the working side dimmer or brighter than usual.
  • Hot smell, buzzing or crackling anywhere near the panel.

Where the lost leg can come from

A leg can be lost at several points. On the utility side, a service drop with a broken conductor, a failed connection at the pole or transformer, or a blown fuse on one leg of a feeder can produce a split outage. Because the utility owns that equipment, it needs to be reported to the power company. A good clue is a neighbor whose house has the same symptoms, or a storm or loud noise just before the outage.

On the customer side, a lost leg can come from a burned connection in the meter socket, a corroded or loose lug at the service entrance, a failed main breaker where one pole has opened, or a burned bus bar inside the panel. South Florida's humidity, salt air and heat accelerate corrosion at connections, and older meter sockets and mains can fail without warning. Repairs to those parts are electrician work and often need a permit and coordination with the utility. Our page on lost leg and no 240-volt appliances explains the failure from the appliance side.

What you can safely check, and what you cannot

Safe checks are those that use your eyes and ears from a dry position, without touching anything that might be energized. Look at the outside of the house for damage to the mast, weatherhead, meter and service line. Look at the panel door from the front without opening the inner cover. Listen for buzzing, humming or crackling at the panel or meter. Smell for a hot, plastic or burnt odor. Check whether neighbors have similar symptoms.

Unsafe actions include removing the panel cover, touching the meter or its seal, probing the main breaker or bus bars, using a plug-in tester on dead outlets as if it proved they were safe, or wiring jumpers between circuits. A circuit tester shows you only whether a single outlet has voltage; it does not show you whether the service is healthy, and it can mislead you when a neutral is lost. Cutting the meter seal is also a violation of utility rules. If you need to switch off power, the main breaker is the right place.

  1. Look and listen from a dry position; do not open the panel interior.
  2. Note which areas and appliances are out and write it down.
  3. Unplug sensitive electronics on the live side.
  4. Switch off the main breaker if you smell burning, hear buzzing or see lights acting strangely.
  5. Call, and report to the utility if there is any outside damage.

Should you turn the main breaker off?

If the half-house outage comes with bright or dim lights, burning smells, buzzing or heat, turning off the main breaker removes the chance that unstable voltage will damage equipment or start a fire. It is a reasonable step if you can reach the panel in a dry area and the main handle is not hot or visibly damaged. Use one firm motion, standing to the side of the panel, and do not touch anything else inside.

If the breaker is hot, scorched, smoking or sparking, do not touch it. Leave the building, call 911 and then the power company. If the house is dark in only one half with no unusual signs, you can decide to leave the main on or off while you wait; turning it off also protects your appliances from a surge when power is restored. Our guide when it is safe to use the main breaker offers more specific guidance, and how to find your main breaker helps if you are not sure where it is.

Condos, townhouses and older homes: where the clues differ

In a condominium, a split outage may be a problem with the unit's own panel, or with the building's riser, meter bank or electrical room. If neighbors above or below have the same symptoms, report it to the building manager or association right away, because the cause may be common equipment you cannot access. Our page on the condo unit power loss and who to call explains how responsibility is usually divided.

In older single-family homes, such as mid-century block houses across Broward County and North Miami, split outages are often linked to aging service equipment: a worn main breaker, a corroded meter socket, or old aluminum or twisted conductors at the service entrance. Some older homes also have fuse boxes, where a blown fuse on one leg can produce the same pattern. In newer homes the cause is more often a failed breaker or a utility-side connection. Whatever the age of the house, the safe response is the same: do not open the panel, switch off the main if there are signs of heat, and have a qualified electrician test it.

What the technician will test on arrival

A technician will start by measuring voltage at the meter socket and at the line side of the main breaker, checking each hot against the neutral and the two hots against each other. That test shows whether both legs reach your service equipment and whether they are balanced. If one leg is missing at the meter, the problem is upstream and the utility is called. If both legs are present at the meter but one is missing at the main, the fault is in the service conductors, the meter socket or the main breaker.

Next comes a visual and thermal inspection: burned lugs, discolored insulation, melted plastic and arc marks on the bus bars. If the main breaker has a failed pole it can be replaced when it is a standard design that is available; a damaged bus bar or an obsolete panel may call for panel replacement. Our pages on urgent breaker replacement and urgent panel replacement describe those repairs. After a repair, the technician rechecks voltages, confirms that the 240-volt loads work, and tests protective devices.

Complicated repairs need an on-site visit before a quote can be given, and quotes are given only by phone. A service call charge applies and is explained on the phone before dispatch.

Protecting appliances and people while you wait

While you wait for a technician or the utility, unplug electronics and refrigerators if the lights are bright or dim, and leave a single lamp switched on in a room you are not using so you can see when power is restored. If the air conditioner is not running, keep doors closed, shade windows and drink water, especially for children, elderly people and pets. If heat is dangerous for someone in the home, arrange to stay somewhere cooler.

Keep children and pets away from the panel, the meter and any area with a burning smell. Do not use extension cords from the live side to run appliances in the dead rooms; that overloads the cord and the circuit. Do not use a portable generator in the garage or connected to a wall outlet. When you call, say that half of the house is out, which appliances are affected, whether any lights are bright or dim, and whether the main breaker is tripped. Then invite the technician in with a clear path to the panel and meter. A split outage is a good reason to call rather than wait.

  • Unplug sensitive electronics and refrigerators if lights act strangely.
  • Keep the area around the panel and meter clear and dry.
  • Do not run extension cords from the live side to the dead side.
  • Never connect a generator to a house through an outlet.

Questions people ask

Does half the house out always mean a lost leg?

No. A tripped breaker, a tripped GFCI that feeds several rooms, or a failed circuit can look similar. A lost leg usually shows up as dead 240-volt appliances plus a large share of lights and outlets, sometimes with lights that are too bright or too dim. Because the cause can only be confirmed with testing, call if the pattern is wide.

Is it dangerous to keep using the half of the house that works?

It can be. If a leg or the neutral has failed, voltage on the working side can be unstable and may damage electronics and appliances. If lights are brighter or dimmer than normal, or you smell something hot, switch off the main breaker and unplug sensitive devices until a technician has checked the service.

Why will my air conditioner and stove not work but the lights do?

Large appliances such as ranges, dryers and central air conditioners use 240 volts, which needs both hot legs. If one leg is missing, lights on the remaining leg still work but the 240-volt appliances stop. That combination is one of the clearest signs of a lost leg and is worth an urgent call.

Should I call the power company or an electrician?

If the neighbors have similar symptoms, or you see damage to the line or pole, call the power company. If the damage is at your meter, mast or panel, or the main breaker is suspect, call an electrician. If you cannot tell, calling both is reasonable. Testing at the meter shows which side of the line the fault is on.

Can I check the outlets with a plug-in tester?

A tester shows whether one outlet has voltage and whether it is wired correctly, but it does not show whether the service is healthy. With a lost leg or a bad neutral, a tester can give misleading results. Treat a split outage as a service-level problem and avoid probing around the panel or meter yourself.

Will a repair need a permit?

Work on the service equipment, such as replacing a meter socket, main breaker or panel, usually does need a permit and an inspection, and the utility often has to disconnect and reconnect power. A technician can explain how that applies to your situation. Smaller repairs, like replacing a single breaker, may be handled differently by your local building department.

Talk to Emergency Electrician

Reading about "Half of the House Lost Power"? Tell us what stopped working and when. We will say what an electrician would check first, and quotes are given by phone when the job can be described.

Related pages

  • Lost Leg: Lights work but the dryer, oven or air conditioner will not run? A lost leg may be the cause. See the symptoms, where the fault can sit and what to do next.
  • Loose Neutral: Lights that get brighter in one room and dimmer in another, buzzing and failing electronics can mean a loose neutral. Learn the signs and why it is urgent.
  • Breaker Replace: A bad breaker can leave circuits dead or overheat in the panel. Learn when replacement is urgent, what is inspected beyond the breaker, and why testing follows.
  • Find Main Breaker: Know where your main breaker is before an emergency. Where to look in homes, condos and businesses, how to recognize it, and what never to touch or open.
  • Only You Dark: Your house has no power but the neighbors do. Learn how to tell a utility fault from a problem on your side of the meter and who to call first.
  • Panel Buzzing: Some panel hum is normal, but loud buzzing can signal arcing or a loose connection. Learn to sort the sounds and what to tell the dispatcher about them.

Mapping what works and what does not before the technician arrives

A short written map of your house can make a half-power problem much easier to solve. Walk through the rooms and note which lights, outlets and appliances work and which do not. Pay attention to the large loads: the air conditioner, the range, the dryer and the water heater. Some run on both sides of the supply, and their behavior is a clue. If a big appliance runs weakly or hums without starting, write that down, because it can be as informative as something that is completely dead.

Also write down anything odd that happened just before the failure, such as a flicker, a bang, a smell, a storm or a large appliance starting. Note whether any lights are unusually bright or dim, since that can point to a loose shared connection that is putting the wrong voltage on a circuit. Where several people share responsibility for the property, agreeing on one contact person avoids mixed messages. Do not test this by plugging in sensitive equipment, because an uneven supply can damage computers, televisions and other electronics in a moment, and the damage may not be obvious until later.

Leave the electronics on the dead side unplugged and keep an eye on anything running on the live side that seems to behave strangely. Do not open the panel cover or touch the wires. Take a photograph of the panel with its door open only if you can do so safely without touching anything inside. Give the technician your map, and the findings will be explained before work starts. Call us to confirm availability and describe what you noticed in as much detail as you can.

Need to discuss an electrical concern or planned project?

Request service

Related pages

Call (954) 481-0910