Electrical help for homes and businessesRequest service
Emergency ElectricianCall (954) 481-0910
Emergency Electrician technician using an infrared camera to inspect a residential electrical panel

Safety and Guides

What Your Electric Meter and Display Can Tell You in an Outage

When the power goes out, the meter outside is one of the few clues you can see without touching anything. A blank display, a lit display or a damaged socket points to different problems. This guide explains what to observe from a distance and how to report it.

Why the meter is a useful clue

The electric meter is the dividing point between the utility's equipment and your home's wiring. Power comes from the utility's lines and transformer, passes through the meter and enters your service equipment, where it is split into circuits. Because the meter sits at that boundary, what it shows can help you decide whether the problem is likely on the utility side, in your service equipment or inside your home.

Most homes today have a digital meter with a small display, and many have a smart meter that communicates with the utility. When the supply is lost, the display behaves in ways that depend on the meter model and on where the loss occurred. A meter with a dark display usually means no power is reaching it, while a lit display means power is reaching the meter even if the house is dark. That single observation is useful.

The meter is also a hazard. It is a sealed, energized piece of equipment, and its socket holds live conductors that do not shut off when you flip a breaker in your panel. Everything on this page is about looking, not touching. You should never open, remove, tap, tamper with or try to pull a meter, and you should never remove the seal or the ring. The purpose of observation is to give a clear report to the utility and to the electrician.

Electrical diagnostic camera, insulated tools, safety glasses, gloves, and Emergency Electrician branded equipment

How to look at the meter safely

Look at the meter from a distance of a few steps whenever possible, in daylight or with a flashlight. Do not stand in water, do not step on wet ground near the meter, and do not lean on or touch the meter, the conduit or the nearby equipment. Do not shine a light through any opening, and do not use a ladder. If the meter is in a closet, a room or an enclosure, do not go in if there is any smoke, smell or water.

Before you go out, consider what is happening around you. If there is a storm with lightning, wait. If there are downed wires, trees on lines or standing water, stay away and see the page on downed wire in the yard. If there is a smell of burning, smoke or sparks at the meter, do not approach. Call 911 and keep others away.

If it is calm and dry, take a photo of the meter face and the surrounding equipment from where you stand. Zooming in with the camera lets you see the display without getting close. Note the time, and note what the display shows. If you cannot see it clearly, do not move closer. Your description of what you can see is enough.

  • Look from several steps away and do not touch any part of the meter or its socket
  • Do not look if there is lightning, standing water, downed wires or sparking
  • Use your phone camera zoom to read the display
  • Never break a meter seal, open a cover or try to remove the meter
  • Note the time and write down what you see
  • If you smell burning or see smoke at the meter, stay away and call 911

A dark, blank display

A meter with a blank display generally means that no power is reaching it. That points to a utility-side problem, such as a downed line, a failed transformer, a blown fuse on the pole or a planned or unplanned outage in the area. It is the most common reason for a blank meter, and it usually means the problem is not inside your home.

Check whether neighbors are also dark. If they are, the cause is very likely an area outage, and the utility's outage reporting is the right channel. If neighbors have power and you do not, with a blank meter, the problem may be in the service line to your property, such as a damaged service drop or underground cable. That is still often on the utility's side of the dividing line, though the dividing line varies, and a technician or the utility can confirm.

A blank display is not always a loss of supply. Some meters blank the display during certain states, and some displays fail while the meter continues to pass power. If your home is lit and the meter is blank, that is a meter problem and should be reported to the utility. If your home is dark and the display is blank, assume the supply is lost until someone proves otherwise.

A lit display with no power inside

A lit meter display with a dark house tells you power is reaching the meter, and the problem is between the meter and your circuits. That points to your service equipment: the meter socket, the main breaker, the service conductors or the panel. It also covers the case where the main breaker has tripped, either from a fault or a surge, and the case where something has failed in the service equipment.

If you can safely reach the panel, dry and easy to access, look at the main breaker. If it is off or in the middle position, it has tripped. Do not reset it repeatedly. One careful reset may be reasonable if nothing smells, nothing looks burned and nothing has been wet, but a main that trips again or will not reset needs an electrician. The page on a tripped main breaker after a storm explains the sequence.

If the main breaker looks normal and the display is lit but the house is dark, the problem may be in the main breaker itself, in the connections from the meter to the panel or in the bus. Those are electrician problems, and you should not open the panel to look. Report to the dispatcher that the meter display is lit and the house has no power, and say whether the panel looks normal. That sentence is very helpful.

Partial power: some things work and some do not

In a home with a 240-volt supply split into two 120-volt halves, losing one leg can leave half the house dark and half lit, with large 240-volt appliances not working at all. In that situation the meter display may still be lit, because power is reaching the meter on at least one leg. The page on half the house has no power and the page on lost leg, no 240-volt appliances describe the pattern.

Partial power can also come from a loose neutral, which can cause some lights to be bright and others dim, appliances to run strangely and electronics to be at risk. If you see that pattern, and especially if the meter or service equipment is buzzing or warm, reduce the load by switching off sensitive devices if it is safe, keep clear of the equipment and call. The page on loose neutral symptoms explains what is happening.

In all these cases, your observation of what is working and what is not, together with the meter display, helps narrow the cause. Write down which rooms are dark, which appliances work and whether the display is lit or blank.

Signs of damage at the meter and socket

Some observations about the meter and socket themselves are urgent regardless of the display. A meter that is crooked, hanging, cracked or missing its cover, a socket that is scorched or melted, a mast or conduit that is bent, a service cable that is sagging, frayed or pulled away, water running into the equipment, and any smoke, sparking or buzzing are all signs of damage.

Stay away from all of those. Keep children and pets away, and do not touch or move anything. If there is smoke, flame or sparking, call 911. Otherwise, call the utility and an electrician. The pages on meter socket sparking, service mast leaning or bent and service cable frayed or sagging describe each case.

A missing or pulled meter, or a meter with a broken seal, may indicate tampering or storm damage. Do not touch it and do not try to put it back. Report it to the utility. A meter that has been pulled leaves the socket's live parts exposed.

Smart meters, utility information and what they can and cannot show

Many utility meters now communicate with the utility by radio, and the utility can often see whether a meter is still reporting. That is why a utility's outage line may be able to tell you whether power is being delivered to your meter without anyone visiting. When you report an outage, give the account or the address, and say whether the display is lit or blank. The utility may confirm an area outage or tell you that its records show your meter is still energized.

A smart meter cannot tell you what is wrong inside your house. It reports to the utility on the supply side, and it has no view of your breakers, outlets or appliances. A meter that shows normal operation does not mean your home's wiring is sound, and a blank meter does not tell you which of the utility's devices failed. Use it as a clue, not a verdict.

Some meters show messages or number sequences on the display, and some utilities publish what those mean. If you see an unusual message, photograph it from a distance and mention it to the utility and the electrician. Do not try to press buttons or change settings on the meter, and do not remove a cover to read a label. The information on the display is meant for the utility, and reading it should never require a risk.

It is also worth knowing that after an outage ends, the restoration can come with surges and brief fluctuations. Switching off sensitive electronics and large appliances before the power returns, and waiting a short while after it returns before turning them back on, can reduce the chance of damage. If anything looks wrong when power returns, such as lights that are very bright, flickering or a smell, switch off the main only if the panel is dry and call.

Who to call, and in what order

If there is fire, smoke, sparks, downed lines, a person hurt or immediate danger, call 911 first. For an outage with no other signs, start by finding out whether neighbors are dark and checking the utility's outage map or reporting line. If the problem appears to be on the utility side, such as a blank meter with a dark neighborhood, the utility is the right contact.

If the meter display is lit and the house is dark, or the meter and service equipment are damaged, or the panel's main will not reset, call an electrician. Where the equipment is damaged or the utility must disconnect service before repairs, the electrician and the utility work in sequence. The page on the power company disconnect and reconnect process explains how that goes.

If you are unsure, calling an electrician and describing what you see is a good start. The dispatcher can tell you whether the problem sounds like the utility's or yours and whether to call 911. The guide on utility or electrician: who fixes what sets out the usual division.

What to say on the call and what to prepare

A good report is short and specific. Say whether the meter display is blank or lit, whether neighbors have power, whether the main breaker looks normal, which parts of the house are dark and whether there was a storm, a bang, a flicker or a smell before the outage. Say whether you see any damage to the meter, mast or service cable, and describe it without touching it.

Share your photos if the dispatcher asks for them. Keep a record of times, since the utility may ask when the outage began. If a technician is coming, clear a path to the panel and meter, secure pets and arrange access to gates and enclosures. If you rent, tell your landlord or manager. Quotes for simple jobs are given by phone. Complicated jobs need an on-site visit, and the service call charge is explained on the phone before dispatch.

Finally, if anything changes while you wait, such as smoke, flame, sparks or a louder buzz, call 911. Otherwise, call now and describe what the meter shows, and the dispatcher will guide the next steps.

Questions people ask

My meter display is blank. Does that mean the utility is out?

Often, yes. A blank display usually means no power is reaching the meter, which points to a utility-side problem. Check whether neighbors are also dark and report to the utility. If your home has power and the display is blank, it may be a display or meter fault, which the utility should check.

The meter is lit but my whole house is dark. What does that mean?

Power is probably reaching the meter, so the problem is between the meter and your circuits, such as a tripped or failed main breaker, a service connection or the panel. Look at the main breaker only if the panel is dry and easy to reach, and do not reset it repeatedly. Call an electrician.

Is it safe to take a closer look at the meter?

Look from a distance only, and not in lightning, standing water or near downed wires. Use your phone zoom. Never open, touch or try to remove a meter or break its seal. The socket has live parts that stay energized when your breakers are off.

The meter was knocked loose by a branch. What should I do?

Stay away, keep others away and do not touch it or the cable. Call 911 if there are sparks, smoke or downed lines. Otherwise, report it to the utility and an electrician. The utility may need to disconnect service before repairs are made.

Half my house is dark and the meter is lit. Is that an emergency?

It suggests a lost leg or a neutral problem, which can cause voltage trouble for devices. Reduce use of sensitive electronics, avoid running large appliances and call promptly. If the meter or panel is buzzing, hot or smelling, stay away and call 911 if there is danger.

How does pricing work for an electrician visit during an outage?

Quotes for simple jobs are given by phone. Complicated jobs need an on-site visit before a quote can be given. There is a service call charge, and it is explained on the phone before dispatch. This site lists no dollar amounts because each situation differs.

Talk to Emergency Electrician

Reading about "What Your Electric Meter and Display Can Tell You in an Outage"? Tell us what stopped working and when. We will say what an electrician would check first, and quotes are given by phone when the job can be described.

Related pages

  • Only You Dark: Your house has no power but the neighbors do. Learn how to tell a utility fault from a problem on your side of the meter and who to call first.
  • Meter Sparking: Sparks or arcing at the electric meter are an emergency. Learn why to call 911 and the utility first, who owns which part and what an electrician does after.
  • Half-House Outage: Half your home lost power while the rest works. Learn why a split outage can mean a lost leg, what you can check safely, and why to call an electrician.
  • Disconnect Process: The usual order of events when a service is pulled for repairs in South Florida: who does what, what gets inspected and why power returns when it does.
  • Find Main Breaker: Know where your main breaker is before an emergency. Where to look in homes, condos and businesses, how to recognize it, and what never to touch or open.
  • Call Order: Electrical trouble, three possible calls. A plain decision order for when to dial 911, when to phone the power company, and when to call an electrician.

Need to discuss an electrical concern or planned project?

Request service
Call (954) 481-0910