Start by keeping your distance
If you can see bare metal, a cable that is lower than it should be, or a jacket that has split open, treat every part of it as energized. Do not assume a wire is dead because the lights inside are still on, or because the lights inside are off. A damaged service cable can be live even when the house is dark, and a cable that looks harmless can still carry full utility voltage.
Stay well back from the cable, from anything it is touching, and from puddles or wet grass beneath it. Keep children, pets and neighbors away. Do not use a broom, a ladder, a pole or a garden tool to move it, and do not try to cut back a branch that is resting on it. Wood, water and aluminum ladders can all carry current in ways that surprise people.
If anyone has been shocked, if the cable is on the ground, or if you see sparks, flames or smoke, call 911 first. Then call the utility and an emergency electrician. Everything else on this page is for the situation where the cable looks wrong but nobody is hurt and nothing is burning.

Utility line or your line: the question that decides everything
Most overhead homes in South Florida are fed by a service drop, a set of conductors that run from a utility pole or transformer to your house. The utility owns and maintains the part that stretches from its pole to the attachment point on your house. From the attachment point to the meter and into the panel, the equipment is typically yours.
The dividing line is usually at the connection near the weatherhead, the curved fitting at the top of the mast or wall where the cable enters. The meter itself is generally utility equipment, but the meter socket it plugs into, the conduit, the mast and the wiring below the weatherhead belong to the property owner. Practices differ between utilities and between older and newer buildings, so a technician will confirm the boundary for your address.
This matters because the utility will respond to a damaged drop, a downed line or a cable that is touching a tree. An electrician cannot and should not touch the utility side. Your electrician handles the customer side: a bent mast, a pulled-away weatherhead, damaged conductors below the connection, a failing meter socket or a corroded service entrance. Calling the wrong party first wastes time during a stressful situation, so it helps to know what you are looking at.
What a sagging cable can mean
A cable that hangs lower than it used to can have several explanations. A mast that has leaned or bent after wind or a falling branch pulls the attachment point downward and slackens the span. A pole that has shifted, or a neighboring tree that has grown into the span, can change the geometry. Old cable can also stretch over many years of heat and load.
Sag is more worrying when it brings the cable within reach of a roof edge, a carport, a pool enclosure, a screen cage, an antenna or a person standing on the ground. Clearance rules exist because people walk, climb and clean in these areas. If you could touch the cable from a ladder, a balcony or a flat roof, it is too low, and it needs attention from the utility, not a homeowner fix.
Sag that appears suddenly after a storm, after a truck strike, or after a branch fell is more urgent than sag that has been there as long as anyone remembers. Take a few photos from a safe distance so the technician and the utility can see how the cable sits. Do not climb to get a closer picture.
Fraying, cracking and rubbed-through jackets
Service conductors are covered in insulation that is designed to survive sun, rain and heat, but it does not last forever. South Florida sunlight is harsh, and years of ultraviolet exposure can make older insulation brittle and chalky. Salt air near the coast adds corrosion at the connections, and humidity keeps moisture working into any gap.
Rubbing is another common cause. A branch that moves in every afternoon thunderstorm can wear through a jacket over months, and a cable that sits against a roof edge, a gutter, a fascia board or a sharp corner of a mast can chafe in the same way. Squirrels and rats occasionally chew at jackets, and a strand of copper or aluminum showing through is an invitation for water.
What you may see: a smooth patch where the jacket is worn thin, a split with dark metal underneath, white or green powder at a connection, a melted or blackened patch, or strands that have separated into a frayed brush. Any of these on the customer side is a repair job for a qualified electrician. Any of these on the utility side should be reported to the utility with the address and the pole number if one is visible.
Signs inside the house that point to a cable problem
Sometimes the first sign of a service cable problem appears indoors. Lights that flicker or surge when wind blows, a pattern of lights that dim and brighten, half the house losing power, appliances that behave oddly, or a faint buzzing near the meter can all point to a damaged or loose connection in the service path.
A damaged neutral conductor is a particular concern. When the neutral is compromised, voltage can shift unevenly between the two halves of the house, so some lights run too bright while others run dim. That condition can damage electronics quickly. If you see this pattern, switch off sensitive equipment if you can do so safely and call for help promptly. Our page on signs of a loose or open neutral describes it in more detail.
A hot smell near the meter or the mast, a crackling sound in rain, or visible arcing at night are signs that the problem is active. In that case, leave the area around the equipment and call right away rather than waiting to see if it settles.
What you can safely do while you wait
The list is short on purpose. You can move yourself, family and pets away from the area. You can keep the yard, driveway and walkway beneath the cable clear. You can photograph the cable from the ground at a distance. You can write down the address, any pole number, what you saw and when you first noticed it.
You should not touch the cable, the mast, the meter or the conduit. Do not pull on a cable that looks loose, do not wrap tape around a split, and do not spray water to rinse off corrosion. Do not pour anything over the cable to cool it. Do not run a ladder up to take a look.
Inside, you may use the main breaker only if you can reach it dry, safely and without standing in water, and only if it is clearly part of the plan you discuss with the dispatcher. Turning off the main does not make the service cable dead, because the cable is ahead of the main breaker. It only de-energizes the house wiring behind it. Our guide on when it is safe to use the main breaker explains the limits.
Who to call and in what order
If someone is hurt, the cable is down, or there is fire or heavy smoke, call 911 first. If the cable is on the utility side and you are not sure, call the utility's emergency line as well, because only the utility can de-energize its own conductors.
If the damage is on the customer side, or if you are not sure where the boundary falls, call the number on this page and describe what you see. The dispatcher will ask where the cable runs, whether it is touching anything, whether the meter looks pulled or tilted, and whether the power is on, off or behaving oddly. Plain descriptions such as 'the cable comes from the pole to the top of the mast and the outer jacket is split near the roof edge' are enough.
Quotes are given only by phone. For a damaged service entrance, the dispatcher will explain the service call charge before anyone is sent, and a complicated repair may need an on-site visit before a quote can be given. Our page on who fixes what between the utility and an electrician helps you sort out the split ahead of the call.
What a technician will check on arrival
A technician arriving for a service cable complaint first looks at the whole path from the attachment point to the panel. They check the mast for bends, rust or loose straps, the weatherhead for cracked housing or pulled conductors, the drip loops for correct shape, and the condition of the cable jacket where it enters the meter socket.
They look inside the meter socket and the main disconnect only when it is safe and appropriate to do so, and they may ask the utility to remove the meter before opening the equipment. For work on the customer side of the connection, a technician usually needs the utility to disconnect power or pull the meter. That coordination is a normal part of the job and can affect scheduling.
Expect questions about when the problem began, whether the storm or a tree strike preceded it, whether there are signs of heat or arcing inside the house, and whether anything has been replaced recently. The technician will explain what is safe to repair on site, what needs the utility, and whether a permit and inspection are likely to apply.
Repair paths: reattach, replace, or rebuild the service entrance
The right repair depends on what failed. If the weatherhead has pulled loose but the conductors are sound, the job may be limited to refastening and resealing. If the jacket of the customer-side conductors is worn or cracked, the conductors themselves are normally replaced rather than taped, because tape is not a lasting repair on a service entrance.
A bent or leaning mast often points to a larger repair. The mast carries the weight of the drop, and a compromised mast can fail again. Replacing it may involve a new weatherhead, new straps, new conductors and coordination with the utility to reconnect. Our page on a leaning or bent service mast covers that path in detail.
Where the meter socket is corroded, melted or loose, the technician may recommend replacing it. See urgent meter base replacement for what that involves. In some older homes a damaged service entrance is the moment to consider a broader service upgrade, but a technician should explain why before recommending it, and the final scope is yours to decide.
Overhead service versus underground service
Not every property has an overhead drop. Many newer subdivisions, townhome communities and condominium buildings in Broward County and the cities from Boca Raton to North Miami are fed by underground conductors that rise out of the ground in a conduit or a pad-mounted transformer. If your cable problem involves something that comes out of the ground, such as a cracked conduit, an exposed cable after erosion or a lawn crew nicking a buried line, the same rule applies: stay away, treat it as live and call.
Underground problems are harder to see and sometimes show up first as a power loss or a tripped main rather than a visible defect. A trench that has washed out after heavy rain, a new fence post driven near the line, or a landscaping project that dug without locating utilities can all damage buried conductors. Florida's locate system exists so that diggers can have buried lines marked before work begins, and a damaged line after digging is a utility emergency.
On overhead services the visible clues are easier: sag, rubbed jackets, torn weatherheads. On underground services, look for a conduit riser on the wall that has cracked or pulled away, a meter socket with soil or water pushed in, or a bulge in the lawn where the ground has settled. Report what you see and let the technician sort out whether the fault lies on the utility side or the customer side of the connection.
Permits, inspection and reconnection
Work on a service entrance often falls under permit rules in South Florida municipalities and counties, and the utility will typically require an inspection approval before it reconnects a disconnected service. The exact steps depend on the city and on how much was replaced. The technician should tell you whether a permit applies before work begins.
That can mean that power is off for longer than the repair itself takes, because the inspector and the utility each have their own scheduling. If you rely on medical equipment, refrigerated medication or a sump pump, tell the dispatcher at the start so options can be discussed. Our guide on the power company disconnect and reconnect process walks through the usual order of events.
Keep every document: the permit, the inspection result, the invoice and any report of findings. If an insurance claim is involved, photographs of the cable before the repair are valuable. When you are ready, call and describe what you see, and the dispatcher will take it from there.
Questions people ask
Is a frayed cable on a pole my problem or the utility's?
A cable that runs from the pole to the attachment point on your house is normally the utility's responsibility, and only the utility can de-energize it. Report it to the utility's emergency line with the address. If the damage is below the connection, at the mast, weatherhead, meter socket or conductors, it is generally on the customer side and an electrician handles it. Call and describe what you see, and the dispatcher will help sort out which side it is.
Can I tape a split in the cable until someone arrives?
No. Taping a service cable means touching conductors that may be live at full utility voltage, and tape does not make a lasting repair on a service entrance. Stay back, keep others away, photograph it from a safe distance and call. If the cable is on the ground, in water or sparking, call 911 first. The repair itself is a job for the utility or a qualified electrician.
My lights are still on. Does that mean the cable is safe?
No. A damaged service cable can remain energized and still deliver power, and the damage can also sit in the neutral, where it causes uneven voltage rather than a blackout. Lights being on says nothing about whether the cable is safe to touch or stand beneath. Treat any visible damage as live, keep your distance, and call for help.
Will turning off the main breaker make the cable dead?
No. The service cable and the meter sit ahead of the main breaker, so they stay energized when you switch the main off. The main only de-energizes the wiring behind it inside the house. It may still be useful for protecting appliances or reducing risk indoors, but it is not a way to make the cable safe to approach. Follow the dispatcher's advice on whether to use it.
A tree branch is resting on the cable. Can I trim it?
Do not trim or push it. Wood can conduct current when damp, and cutting a branch can drop it onto the cable or swing it into one. Trees touching utility conductors are a utility matter, and the utility has its own crews for that. Report the location, keep people clear, and photograph the branch from a distance if it is safe to do so.
How do I get a price for repairing a service cable?
Quotes are given only by phone. The dispatcher will explain the service call charge before anyone is sent. Because service entrance repairs often involve coordination with the utility and sometimes a permit, a complicated job may need an on-site visit before a quote can be given. Have the address, what you see and whether the power is on ready when you call.
Reading about "Service Drop or Cable Frayed or Sagging"? Tell us what stopped working and when. We will say what an electrician would check first, and quotes are given by phone when the job can be described.
Related pages
- Bent Mast: A service mast bent or pulled by a tree, wind or a sagging line is a hazard. Learn what to do, how to work with the utility and what repair and permits involve.
- Torn Weatherhead: A torn or leaking weatherhead lets rain run down the conduit toward the meter and panel. Learn the danger, the order of coordination and what repair involves.
- Meter Sparking: Sparks or arcing at the electric meter are an emergency. Learn why to call 911 and the utility first, who owns which part and what an electrician does after.
- Mast Repair: A bent, torn or storm-damaged service mast or weatherhead is a hazard. Learn who disconnects power, who repairs what, and how permits and inspection work.
- Tree on Line: A tree pulled down the service line to your house. Learn who handles mast, drop and conduit damage, what to avoid, and how to coordinate the repair.
- Small Fire: Small flames at an outlet, cord or appliance still mean get out and call 911. Learn why water is wrong, when an extinguisher is an option and what follows.
